Cutting tool for 8mm wide paper carrier tapes

By placing the tapes holes on to the positioning pins, anyone can simply perform the same cutting consistenly and accurately. There is no need to worry about cutting off the work. By making the cut part a zigzag shape, the top tape can be easily peeled off and does not interfere with mounting.

Pazzle Spliser Cutting tool for carrier tapes

By cutting the tips of 8 mm wide tape in a puzzle shape, it is possible to connect them without a metal plate. This jig can be used for positioning and trimming of old and new carrier tapes, and pasting of splicing tapes. Since the tip of the new tape is cut into a shape that is easy to peel off, there will be no problems where the top tape cannot be peeled off, and there is no problem in mounting. Stable splicing that does not depend on the skill of the operator can be realized.

※Use of the dedicated splicing tape ST-EPS is assumed.
※Explanation movies are available at the bottom of this page.

crimping jig & Caulking Metal plate

When you want strength, such as connecting wide embossed carrier tapes or single-sided tapes, or preventing misalignment at the joint, a plate is crimped using a crimping jig to connect the tapes.

HANDY JIG

This is a portable and palm-sized simple positioning jig. After cutting the carrier tapes with scissors, splicing without mistake can be performed by fixing them with the positioning pins of the Handy Jig. It is compatible with 8 mm embossed / paper carrier tape.

※Use of the dedicated splicing tape ST-EPS is assumed.

Protective tape to prevent parts from falling off during storage

When removing a carrier tape from a mounter to store it, peeling of the top tape or falling off of parts can be prevented by covering the tip with this tape. Since the carrier tape can be reattached and mounted on the mounter with this tape attached, parts will not fall off while it is peeled off. This tape is compatible with all carrier tape widths. It is recommended when frequent process changes are required such as small lot multi-product mounting.

Chip Tack Tape

For reuse of inspection substrates and parts

This tape demonstrates the mounting of chip components.This tape adheres the PCBs to the test mounting, then it confirms whether components are adhered properly by mechanical inspection machine.This tape is reusable when the supply of PCBs and parts is not sufficient.You can reuse the PCBs and components after the demonstration because you can peel the tapes off　without the adhesive compound sticking to them.The strength of the peel is stronger than the standard double-stick tape, as a result when peeled off　the thin PCBs do not break.This is extremely effective while mounting numerous chip devices on large-sized PCBs.

Top Tape Removal Gun

Easy Removal of top tape with suction type

The top tape accumulated in a feeder is recovered by vacuum suction into an attached zipper bag. The troublesome Removal work can be completed in a few seconds. The top tape stored in the bag can be easily disposed of by opening and closing the zipper. In addition, if a branch line is connected to a compressor, no power supply is required, and the gun can be used immediately, and another advantage is that it can be easily introduced.

※Explanation movies are available at the bottom of this page